Switch Brake

Mosfet with built-in active brake, which can be switched off simply by pulling the red jumper.
The device is designed to be replaced by a micro switch on a specific V2 mechabox.
Installation is without modification to the weapon.
The piston is not partially cocked during semi-firing, the spring does not fatigue, internal parts are not stressed, and the nozzle largely locks the chamber.
For high-cadence guns, it solves the problem of multiple shots in semi-firing mode.
The device increases the weapon's cadence and battery life over the original wiring in the weapon.

• Easy installation inside the mechabox v.2 instead of a micro switch
• Separate device without cables, cables with max. cross-section 1.5 mm2 can be used for the power circuit and max. cross-section 0.5 mm2 for the signal circuit
• Suitable for service centres, if you are not sure about soldering the wires to the board, choose the version with wiring and accessories.
• Pull out the jumper to disconnect the active deceleration when your gun has a cadence below 20 rounds/sec, otherwise the breaker could then stay in the top position and not be able to fire again.
• Without active braking, there is less strain on the engine.
• Designed for springs up to M160 (equivalent to 75A current for single shot or 25A batch shooting for max 30s)
• Designed for all types of commonly used batteries up to 17V (Ni-xx 8.4 - 12V, Lipol 7.4 - 14.8V)
• No current is drawn in the resting state
• Due to the principle of the AEG gun mechanism, the piston stops in a random position during AUTO mode
• For this device to function properly, the mechabox must have a working breaker, switch backlash, trigger and trigger stop (secured), i.e. as in a standard mechabox

  ---

  WARNING: A professional is required to install this device and must be able to solder and disassemble the AEG gun. Never use a soldering iron!

• This device is not compatible with the PTS masada, which has a reversed trigger action